Knowledge of aluminum anti-static floor installati

2022-07-22
  • Detail

Anti static floor is generally used in the decoration with more electronic use, such as network control, monitoring control, computer teaching, computer room control and so on, and less household use. Now let's introduce the knowledge of aluminum anti-static floor and the installation process of anti-static floor. Let's have a look

anti static floor is generally used in decoration with more electronic use, such as network control, monitoring control, computer teaching, computer room control and so on, and less household use. Now let's introduce the knowledge of aluminum anti-static floor and the installation process of anti-static floor. Let's have a look

I. aluminum anti-static floor knowledge

1. Floor specification

generally, the length of the floor is 600 mm or 602 mm, while the thickness of the floor is 30 mm, 35 mm, 40 mm and 45 mm, while the support beam matching the floor is 150 mm, 200 mm and 300 mm

2. Floor veneer

generally, the veneers commonly used for anti-static floors are HPL veneer, PVC veneer and ceramic veneer. Different veneers are suitable for different environments and ways, so you should know which veneer is suitable for you before purchasing

3. Service environment of the floor

the service environment temperature of the floor should preferably be between 10 ℃ and 30 ℃, and the relative humidity of the air should be maintained at 30% to 70%

4. Protection of anti-static floor

the anti-static floor installed in the machine room should be cleaned regularly. The surface of the floor should not be washed directly with a large amount of water, but wiped with a wrung mop, so as to prevent the corrosion of the floor. It is not allowed to squeeze the floor with hard objects and sharp tools, which is easy to impact the floor and cause damage to the floor

II. Installation process of aluminum anti-static floor

1. Before installation, you should first observe the layout of the whole room, and then set the installed infrared horizontal scanner at half waist level around the wall, and then find out the lowest and highest points of the room, calculate the average value from the ground to the board, and adjust the height of the support

2. According to the position of the floor grid line, place the support and beam, and then adjust the support of the screw to make the level and height of the beam and the elevation control line consistent. Wait until all the supports and beams are at the same level, and then swing them to the cross intersection of the ground grid line

3. When laying the floor, you can use the bubble level to level the floor one by one. When laying the last row, you should first fix the angle iron in the surrounding corner, and then cut the surrounding floor. In addition, there must be a support on the back of the angle iron, so that people will not shake and sound when walking on it

editor's summary: the above is all about the knowledge of aluminum anti-static floor and the installation process of aluminum anti-static floor shared by editor. When installing the anti-static floor, it must be installed according to the installation process and standard points, so that it can be installed more beautifully and used for a longer time

郑州癫痫医院

西安妇科医院

成都精神医院

Copyright © 2011 JIN SHI